Installing Components In The Base - Automation Direct DL205 Manual

2–11
Installation and Wiring

Installing Components in the Base

When inserting components into the base, align the PC board(s) of the module with
the grooves on the top and bottom of the base. Push the module straight into the
base until it is firmly seated in the backplane connector. Once the module is inserted
into the base, push in the retaining clips (located at the top and bottom of the module)
to firmly secure the module to the base.
CPU-slot device must be
Align module to
positioned in the first slot of
the base
slots in base and slide in
Push the retaining
clips in to secure the module
to the DL205 base
WARNING: Minimize the risk of electrical shock, personal injury, or equipment
damage. Always disconnect the system power before installing or removing any
system component.
DL205 Installation and I/O Manual , Rev. B