Preliminary Checks; Electrical Installation - Electrical Connections - Tecnosystemi HI-TECH PUR 4.0 User Manual

4.9 PRELIMINARY CHECKS

Before starting up the machine, it is necessary to carry out preliminary checks on the electrical and hydraulic parts.
Commissioning operations must be performed in compliance with all the provisions of the preceding
paragraphs.
Malfunctions or damage may also result from the lack of proper care during shipping and installation.
It is good practice to check before installation or commissioning that there is no damage due to
tampering, vibrations during transportation or mistreatment suffered on site.
• Check that the machine is installed to a professional standard and in compliance with the indications of this manual.
• Check the electrical connection and the correct fastening of all the terminals.
• Check that the voltage is the one shown on the unit data plate.
• Check that the machine is connected to the earthing system.
• Check that the hydraulic connections have been installed correctly and that all the indications on the plates are
respected.
• Before starting ignition, check that all the closing panels are in their position and are fastened
Do not modify the electrical connections of the unit, otherwise the warranty will immediately expire.

4.10 ELECTRICAL INSTALLATION - ELECTRICAL CONNECTIONS

The installation and electrical connection of the device must be carried out by qualified personnel and in compliance
with the laws in force in the country in which the installation is performed.
The installation and electrical connection of the device must be performed by qualified personnel and in compliance
with the laws in force in the country in which the installation takes place.
Connection to the mains:
• The product must be connected to the mains to supply the power necessary for its correct operation.
• The cable sections must be adapted to the local regulations in force.
• The power line must be equipped with a circuit breaker.
• Before making any connections or working on the device, make sure that the power supply is disconnected.
Disconnect the power before removing the product from its assembly support.
58