PostScript
SIMM
Installing a
PostScript SIMM
Caution
1
Power OFF the printer and disconnect the power cord and any interface cables.
2
Loosen the thumb screws and pull out the
controller board.
A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s
I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s
This section contains two sets of instructions:
•
"Installing a PostScript SIMM" (below)
•
"Removing a PostScript SIMM" (page C-12)
SIMMs and controller boards are sensitive to static electricity.
Before installing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the installation,
again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
3
Place the controller board on a ream of
paper.
C-9