Using The 500-Sheet Paper Deck And Cassette - Xerox DocuPrint 4517 User Manual

L o a d i n g P a p e r
Using the
500-sheet Paper
Deck and Cassette
Caution
2-12 D o c u P r i n t 4 5 1 7
The optional 500-sheet Paper Deck and Cassette holds 500
sheets of 20 lb (75 g/m
Paper" (page 2-3) for acceptable paper sizes and weights.
(See Appendix A for ordering information and Appendix C
for installation instructions.)
• Do not attempt to load the 500-sheet Paper Deck and
Cassette during printing.
• Do not overfill the paper cassette.
If you are not changing paper size, go to
Step 2.
1
2
/
4 5 1 7 m p U s e r G u i d e
2
) paper. Refer to the section "Selecting
Adjust the end and width guides to fit the
size of paper you are loading.
A
Lift up one side of the end guide (1) at
the rear of the tray, then lift up the
other side of the end guide.
B
Pull out the tray to lengthen it, or push
it in to shorten it.
C
Press both sides of the end guide down
until it clicks into place at the desired
length.
D
Slide the width guide (2) to fit the
width of the paper.
Load paper. Refer to Figure 2.4 on
page 2-13 for correct paper orientation.