Table of Contents
Advertisement
C o n t r o l P a n e l M e s s a g e s
Table 6.2
Control Panel messages (continued)
Message
Page Too Complex
Paper Jam-
Open Front Cover
Paper Jam-
Open Rear Cover
Paper Size Jam-
Open Rear Cover
PCL Font List
Printing...
6-20
D o c u P r i n t 4 5 1 7
Description/Corrective Action
In PCL or PostScript, the printing on a page is broken into horizontal bands. When
the Page Protection option is set to Off, as a page is processed, each band has a
limited time to be composed and imprinted on the page.
means the current page cannot print because there is not enough time to
compose it.
ACTION:
Press Enter
continue. The page that was too complex may be printed on more
than one sheet of paper. To achieve correct printing, set the Page
Protection option to the appropriate page size (or to On for
PostScript) and send the print job again. Refer to the section "Memory
Considerations" (page 1-11) for information on Page Protection
memory considerations.
Even though Auto Continue may be On, you will see the message
below for ten seconds:
Press *
The printer waits ten seconds, then resumes (in effect, pressing
Enter
for you).
Paper has jammed at the EP (print) cartridge. The message alternates with:
Remove PrintCart
Clear Paper Path
ACTION:
See "Print Cartridge Jam" (page 6-35).
Paper has jammed in the rear of the printer. The message alternates with:
Clear Paper Path
or (if a Duplex Module jam):
Remove DuplxUnit
Clear Paper Path
ACTION:
See "Paper Exit Jam" (page 6-34) or "Duplex Module Jam"
(page 6-34).
Paper has jammed due to being the incorrect size. The message alternates with:
Clear Paper Path
ACTION:
See "Paper Mismatch Jam" (page 6-35).
The PCL Font List is printing.
ACTION:
Remove the PCL Font List from the output tray when it has finished
printing.
/
4 5 1 7 m p U s e r G u i d e
. The page will be ejected and the print job will
Page Too Complex
Table 6.2 Page 15 of 22
Advertisement
Table of Contents
Troubleshooting
