Xerox DocuPrint 4517 User Manual page 184

H a r d D r i v e
4
Align the hard drive connector to the
controller connector (J180), and gently lay
the hard drive on top of the four standoffs.
C-16 D o c u P r i n t 4 5 1 7
5
6
7
/
4 5 1 7 m p U s e r G u i d e
Push down on the drive until all four
corners latch into place.
Replace the controller board, sliding it
along the alignment channels. Then
hand-tighten the thumb screws.
Replace the power and interface cables
and power ON the printer.
If the drive is already formatted, the
Control Panel will display:
Online
Ready
If the drive is unformatted, the Control
Panel will display:
Press to Init
Press to Abort
If any other message is displayed, see
Table 6.2 starting on page 6-6.
If you need to format the drive, continue to
Step 8 on page C-17. Otherwise, skip to
Step 9 on page C-17.