E n v e l o p e F e e d e r
Removing the
Envelope Feeder
1
Power OFF the printer and disconnect the power cord(s).
2
Lift the Envelope Feeder up and out from
the printer.
Store the Envelope Feeder in its
original packaging materials, or in a
dry, dust-free place.
C-52
D o c u P r i n t 4 5 1 7
3
4
5
/
4 5 1 7 m p U s e r G u i d e
Re-attach the face plate that was removed
when the Envelope Feeder was installed.
Close the hinged clasp at the left side of
the Front Tray.
Close the Front Tray if not needed.
Reconnect the power cord(s) and power
ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.