C o n t r o l P a n e l O p t i o n s
Table D.1
Control Panel menu options, settings, and descriptions (continued)
Menu Option,
Location(s),
Setting(s)
Ethernet Menu
†
Interface Menu
†
Appears only when the
XNIC-E'NET option is
installed.
†
Fmt LwrMacroCard
Test Menu
†
Appears only when the
macro card is installed.
Fmt UprMacroCard
†
Test Menu
†
Appears only when the
macro card is installed.
Font Number
PCL Emulat Menu
0* - 999
Font Source
PCL Emulat Menu
Internal*
†
Upper
†
Lower
Soft†
†
Appears only when there
are fonts in these
locations.
D-8
D o c u P r i n t 4 5 1 7
Invokes the Ethernet Menu.
Causes the Lower Macro card to be formatted or reformatted.
This action erases all data on the macro card. It must therefore be
confirmed before it is executed.
Causes the Upper Macro card to be formatted or reformatted.
This action erases all data on the macro card. It must therefore be
confirmed before it is executed.
Specifies the ID of the default font in PCL.
Only values valid for the
Font Source
have internal fonts only, the maximum Font Number is 52.
Font Number
values are printed on the PCL Font List in the first column. Print a
PCL Font List to find the correct number to use with this setting.
Hold Up
or Down
scrolls in increments of 10.
Font Number
The
setting returns to its factory setting (0) if
(page D-22) is changed. If the
other than Internal,
Location of the default font in PCL.
Internal refers to the font set residing in the printer's permanent memory. These
fonts are resident in the printer and cannot be altered.
Upper and Lower refer to the two font card slots and appear only when a font
card is installed in a slot.
The
Font Source
setting returns to its factory setting (Internal) if
Symbol Set
(page D-22) is changed. If the
location other than Internal,
/
4 5 1 7 m p U s e r G u i d e
Description
location are displayed. For example, if you
for approximately two seconds and
Font Source
setting specifies a location
Font Number
reverts to 0 automatically.
Font Source
Font Number
reverts to 0 automatically.
Font Number
Symbol Set
setting specifies a
Table D.1 Page 6 of 21