M e m o r y S I M M s
4
Carefully push out on the locking clips to
release the SIMM.
C-8
D o c u P r i n t 4 5 1 7
5
6
7
/
4 5 1 7 m p U s e r G u i d e
Rotate the SIMM down out of position,
then lift it out.
Replace the controller board, sliding it
along the alignment channels. Then
hand-tighten the thumb screws.
Replace the power and interface cables
and power ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.