Common Postscript Problems - Xerox B210DNI User Manual

Symptoms
Before printing, the
printer emits vapor
near the output tray.
The printer does not
print special- sized
paper, such as billing
paper.

Common PostScript Problems

The following situations are PS language specific and may occur when several printer languages are
used.
Symptoms
PostScript file cannot
be printed.
"Limit Check Error"
report prints.
A PostScript error page
prints.
Causes
Using damp paper can cause vapor
during printing.
Paper size and paper size setting do not
match.
Causes
The PostScript driver may not be
installed correctly.
The print job was too complex.
The print job may not be PostScript.
Solutions
• Load a new batch of paper.
• To avoid the paper absorbing too
much moisture, do not open
packages of paper until required.
Set the correct paper size in the Custom
Paper Size Settings in the Print Options.
For details, refer to Paper
Solutions
• Install the PostScript driver. Refer to
Installing Printer Software.
• Print a configuration page and verify
that the PS version is available for
printing.
• If the problem persists, contact a
service representative.
You might need to reduce the
complexity of the page.
Make sure that the print job is a
PostScript job. Check to see whether the
software application expected a setup
or PostScript header file to be sent to
the printer.
Xerox B210 Printer
®
User Guide
Printing Problems
Tab.
150