Can Not Receive Any Response Procedure After Sending Eor_Null; Received Incorrect Response After Sending Eor_Mps; Received Err Signal After Sending Eor_Mps; Can Not Receive Any Response In Rr Response Procedure After Sending Eor_Mps - Olivetti PF-P09 Service Manual

20. FAX ERROR
(70) Error code: 00F0
Definition

Can not receive any response procedure after sending EOR_NULL.

Solution 1.
2.
3.
4.
5.
(71) Error code: 00F1
Definition At phase D, transmitting units out EOR_MPS 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
5.
(72) Error code: 00F2
Definition

Received incorrect response after sending EOR_MPS.

Solution 1.
2.
(73) Error code: 00F3
Definition

Received ERR signal after sending EOR_MPS.

Solution 1.
2.
(74) Error code: 00F4
Definition

Can not receive any response in RR response procedure after sending EOR_MPS.

Solution 1.
2.
3.
4.
5.
(75) Error code: 00F5
Definition At phase D, transmitting units out EOR_EOP 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
5.
336
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Field Service Ver. 1.1 May 2011