13. SERVICE MODE
13.4.11
LEFT ADJ. (BACK)
A. Use
• To correct a misaligned print image.
TRAY 1: Adjust the left margin of media fed from tray 1 (manual tray.)
TRAY 2: Adjust the left margin of media fed from tray 2.
TRAY 3: Adjust the left margin of media fed from tray 3.
B. Procedure
1. Select [LEFT ADJ. (BACK)] and press the Select key.
2. Select desired tray and press the Select key.
3. Select desired adjustment amount with the up key /down key
key.
4. Select desired setting value with the up key /down key
13.4.12
TRANSFER POWER- SIMPLEX PASS
A. Use
• Adjust the 2nd image transfer output (ATVC) on the single-sided pages for each media
type.
• To use when the transfer failure at the trailing edge occurs.
B. Procedure
• The default setting is 0.
1. Select [TRANSFER POWER] and press the Select key.
2. Select [SIMPLEX PASS] and press the Select key.
3. Select desired media type with the up key /down key
4. Select desired setting value with the up key /down key
<Adjustment instructions>
To increase the ATVC value (in the direction of a foggier image), decrease the setting value.
To decrease the ATVC value (in the direction of a less foggy image), increase the setting
value.
144
-15 to +15 (1 step: 0.21 mm)
-8 to +7
Field Service Ver. 1.1 May 2011
and press the Select
and press the Select key.
and press the Select key.
and press the Select key.