At Phase D, Transmitting Units Out Eom, But Receive Dcn - Olivetti PF-P09 Service Manual

Field Service Ver. 1.1 May 2011
(38) Error code: 00C5
Definition Received DCN signal after sending MPS signal.
Solution 1.
2.
(39) Error code: 00C9
Definition At phase D, sending MPS 3 times consecutively, but no answer from receiving unit.
Solution 1.
2.
3.
4.
5.
6.
(40) Error code: 00CA
Definition After sending EOP signal, the received is not one of MCF, RTN, PIP, PIN, PRI-EOP,
DCN.
Solution 1.
2.
(41) Error code: 00CB
Definition After sending EOP signal, the received is DCN signal.
Solution 1.
2.
(42) Error code: 00CC
Definition After sending EOM signal, the received is not one of MCF, RTN, PIP, PIN, RTP, DCN.
Solution 1.
(43) Error code: 00CD
Definition At phase D, transmitting units out EOM 3 times consecutively, but receive no answer.
Solution 1.
2.
3.
4.
5.
6.
(44) Error code: 00CE
Definition

At phase D, transmitting units out EOM, but receive DCN.

Solution 1.
2.
Resend the FAX again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Adjust the SOFT SW02 [7-8] to "01" or "10" or "11", then resend it again.
Set SOFT SW21 [5] to "1" (T4 timer = 4.5 sec.)
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Adjust the SOFT SW02 [7-8] to "01" or "10" or "11", then resend it again.
Set SOFT SW21 [5] to "1" (T4 timer = 4.5 sec.)
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
20. FAX ERROR
331