Field Service Ver. 1.1 May 2011
13.4.8
FUSER CONTROL
A. Use
• Sets the heater lamp lighting control so that it implements the flicker standards.
• To use when flickering from fluorescent light occurs.
0: Flicker Control is determined according to an area code (Default)
1: Flicker Control is always on (disregarding area code)
2: Flicker Control is always off (disregarding area code)
B. Procedure
• The default setting is 0.
13.4.9
TOP ADJ (FRONT)
A. Use
• To correct a misaligned print image.
PLAIN PAPER: Adjust the head margin of plain paper.
THICK1: Adjust the head margin of thick paper.
THICK2: Adjust the head margin of thick paper.
ENVELOPE: Adjust the head margin of envelope.
B. Procedure
1. Select [TOP ADJ (FRONT)] and press the Select key.
2. Select desired paper type and press the Select key.
3. Select desired adjustment amount with the up key /down key
key.
13.4.10
LEFT ADJ. (FRONT)
A. Use
• To correct a misaligned print image.
TRAY 1: Adjust the left margin of media fed from tray 1 (manual tray.)
TRAY 2: Adjust the left margin of media fed from tray 2.
TRAY 3: Adjust the left margin of media fed from tray 3.
B. Procedure
1. Select [LEFT ADJ. (FRONT)] and press the Select key.
2. Select desired tray and press the Select key.
3. Select desired adjustment amount with the up key /down key
key.
-15 to +15 (1 step: 0.21 mm)
-15 to +15 (1 step: 0.21 mm)
13. SERVICE MODE
and press the Select
and press the Select
143