Olivetti PF-P09 Service Manual page 366

Field Service Ver. 1.1 May 2011
(49) Error code: 005E
Definition Can not detect control channel signal after received RCP frame within 6 seconds.
Solution 1.
2.
3.
4.
(50) Error code: 0060
Definition There are no bulletin files to be polled in V.34.
Solution 1.
(51) Error code: 0061
Definition Machine can not detect V.21 or V.8 signal within 35 seconds.
Solution 1.
2.
3.
(52) Error code: 0062
Definition Modem disconnect in phase D after our side sending out flags sequence in control
channel.
Solution 1.
2.
3.
(53) Error code: 0063
Definition Can not receive any flag sequence in control channel within 6 seconds in phase D.
Solution 1.
2.
3.
(54) Error code: 0064
Definition Can not detect any control channel signal in phase D within 60 seconds even
through energy still on the line.
Solution 1.
2.
3.
Ask sender resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Polling TX is not available.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
20. FAX ERROR
323