Appletalk - Xerox FaxCentre 2218 System Administration Manual

AppleTalk

Use these instructions to install the WorkCentre 4118 / FaxCentre 2218 on an AppleTalk
network using CentreWare Internet Services.
Installation Procedure
There are two stages required to install the device on an AppleTalk network using CentreWare
Internet Services:
Configure the WorkCentre 4118 / FaxCentre 2218
Test Print
Configure the WorkCentre 4118 / FaxCentre 2218
To complete the installation of the WorkCentre 4118 / FaxCentre 2218, perform these steps:
Open CentreWare Internet Services (see Accessing CentreWare Internet Services on
1
page 7-4).
At the CentreWare Internet Services Home Page for the WorkCentre 4118 / FaxCentre
2
2218, select the [Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
4
then select the [+] symbol to the left of the Protocols folder.
In the Properties frame, within the Protocols folder, select [AppleTalk].
5
Make the following selections and settings in the AppleTalk Physical Configuration section
6
of the Protocols frame:
Click the [Apply] button to implement any changes.
7
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide
This procedure explains how to use CentreWare Internet Services to
configure the device.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Select the checkbox to enable AppleTalk.
Enter the [Printer Name]. Use a meaningful name, such as the location of the
device.
Choose the Zone where the printer resides from the drop-down menu.
Page 7-7