Installation Procedure
The following drivers are provided PCL6, PostScript
Scan and ControlCentre. You can install many of the drivers that you require at the same time.
NOTE:
recommended that you use the instructions relevant to the specific network requirements.
The WorkCentre 4118 / FaxCentre 2218 can be connected directly to the parallel port or USB
of a host workstation. A document file can be sent or received from the host workstation via
the appropriate port to the WorkCentre 4118 / FaxCentre 2218.
There are three stages required to install the WorkCentre 4118 / FaxCentre 2218 on a port on
a local workstation:
Install the driver.
Workstation Setup
Test Print or Scan
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide
The drivers will be installed to the local port. For network connections, it is
This requires the appropriate printer driver to be installed on the workstation.
This requires the workstation to be configured to print to the WorkCentre
4118 / FaxCentre 2218.
A print job should be submitted to ensure the WorkCentre 4118 / FaxCentre
2218 has been installed and configured correctly.
®
TM
3
compatible, Macintosh PPD, Linux,
Page 8-3