Tcp/Ip - Xerox FaxCentre 2218 System Administration Manual

TCP/IP

Use these instructions to install the device on a TCP/IP network using CentreWare Internet
Services.
Installation Procedure
There are two stages required to install the device on a TCP/IP network using CentreWare
Internet Services:
Configure the WorkCentre 4118 / FaxCentre 2218
Test Print
Configure the WorkCentre 4118 / FaxCentre 2218
NOTE: The TCP/IP settings for the device will have been setup when completing the Open
CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
Open CentreWare Internet Services (see Accessing CentreWare Internet Services on
1
page 7-4).
At the CentreWare Internet Services Home Page for the WorkCentre 4118 / FaxCentre
2
2218, select the [Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
3
then select the [+] symbol to the left of the Protocols folder.
Select [TCP/IP] and check the Protocol Configuration details are correct. If any of the
4
details are incorrect then enter the correct information.
In the Physical Connection field, Ethernet will be the default setting.
5
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide
This procedure explains how to use CentreWare Internet Services to
configure the device.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Enter the [Host Name].
Choose the [IP Address Resolution] required.
Page 7-9