Set Factory Defaults - Xerox FaxCentre 2218 System Administration Manual

4
Press
Network displays and press
[Enter].
NOTE: Refer to Section 2 Basic Network Installation and Section 6 Advanced TCP/
IP Setup for details on network configuration settings at the device.

Set Factory Defaults

To reset the factory defaults:
1
Press the [Machine Status]
button.
2
Press
Admin Tools displays and press
[Enter].
If the System Admin Tools has
already been passcode
protected, type in the password
and press [Enter].
3
Press
Setup displays and press [Enter].
Page 10-4
or until Config
or until System
or until Network
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide
Network Setup
[Config Network]
Machine Setup
Fax Setup
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]