Table of Contents
Advertisement
•
9. STOP MODE OPERATION
MELSEC-A
9.7
Confirming the Format Information of a Memory Card
[Function]
This function displays the format information of a memory card installed in
the G-controller module on the screen of a PC/AT.
The operation using this function is executed from a PC/AT as shown below:
(1)
Operating conditions
(a) This function can only be used with a memory card formatted by the
operator.
(b) The display contents are the sizes of each area of a memory card
formatted by the operator.
(2)
Setting the G-controller RUN/STOP keyswitch
During memory card information confirmation, setting the RUN/STOP
keyswitch to RUN or KEY LOCK automatically puts the G-controller into
the monitor mode, starting or resuming monitoring.
(3)
Memory card installation/removal
Section 4.3.3 explains how to install and remove memory cards.
[Operating procedure]
(1)
Memory card information confirmation procedure
After displaying the STOP mode menu screen (see [Function] in Section
9.6, this operation can be executed using the AD57GPE installed in a
PC/AT.
See the AD57GPE Operating Manual.
9-15
Advertisement
Table of Contents
