Table of Contents
Advertisement
9. STOP MODE OPERATION
MELSEC-A
(2)
Formatting operating procedure
(a) Select items.
Set the items mentioned in (b) to (I) below by using the [tJ and [!] keys.
(b) Select a memory card to be formatted (Item: Memory card)
Designate the location of the memory card to be formatted by using
the
[~l
and
[~l
keys.
(c) Designate the card memory size (Item: Card memory size)
Designate the memory size of a memory card to be formatted by
using the
[~]
and
[~]
keys.
256
~_I-I_-
512
1024
I
If an incorrect memory size is specified, the following occurs:
If the designated size is smaller than the actual size, only the
designated area is formatted and can be used.
If the designated size is larger than the actual size, a format error
occurs. In this case, designate the correct size and reformat.
POINT
I
The size of a memory card is determined by the following equation:
Card size
Designated in (c)
(d) Designating the monitor data storage area size (monitor data area)
Select a value using the
[~]
and
[~]
keys, and designate a size
which can store all monitor data (screen data + monitor condition
data).
When monitor data is not stored, select o.
Monitor area size
Designated in (d)
File area size
Designated in (e)
+
System monitor area size
Designated in
(f)
•
(Increases/decreases in units of 64K bytes)
o
64
128
_
...
-
- " ' -
1024
The size of monitor data to be stored is displayed on the screen of
the PC/AT after the conversion using the AD57GPE.
Appendix 1 gives the required memory capacities for each monitor
function.
9-6
Advertisement
Table of Contents
