Operator Function
2.2 WHEN AN ERROR OCCURS
▶ When you try to enter Supervisor Mode or go into IN SERVICE MODE from supervisor
menu, the screen below will be displayed if there is any ERROR.
Press DEVICE INITIALIZE button, if the error is caused by a device so it can be cleared
by initializing.
Press OPERATOR FUNCTION button, if you have to set up any information to clear the
error. And set up the information which is missed.
<Note!>
If the machine goes out of service, the error code will not always appear on the screen.
If you do not see an error code, enter operator function and go to reports. Look in the
error summary for error codes.
© Hyosung TNS Inc. All Rights Reserved.
Chapter 2. BASIC SYSTEM OPERATION
2-13