Error Code Table - HYOSUNG NH-1800CE Operator's Manual

NH-1800CE
D. ERROR CODE TABLE
D.1 Receipt Printer
Error Code
1106910 LOST SLIP", DEV_SPR
2001000 Receipt paper jam
2001200 Receipt printer feed plate open
2001300 Out of receipt (Receipt paper empty)
2001400 Receipt printer head overheated before printing
2010100 Receipt printer lever opened
2010200 Receipt printer head overheated
2010300 Receipt paper jam
2010400 Receipt paper empty
2010500 Receipt paper setting error
2010600 Command is received while doing self-test
2010700 No receipt paper
2010800 Receipt paper cutting error
2010900 No sensing black mark (dark sensor)
2010A00 The size of image print data is abnormal
2080100 Receipt printer lever opened
Description
6- 11
Trouble shooting
Remove any jammed paper from the printer.
Close the feed plate.
Replenish the receipt paper.
Check the printer head and change if necessary.
Close the lever of print head completely
Wait the time until the temperature of head
adequately slow down and try to initialize
Remove jammed paper between printer head and
rollers
1. Replenish receipt paper
2. Check the status of sensor and its connector
1. Check the status of setting paper
2. Check the status of sensor and its connector
After terminating self-test and initialize receipt
printer
1. Replenish receipt paper in paper charger
2. Check the status of Near End sensor and its
connector
1. Check the Cutter module
2. Check if printer head lever is properly close
1. Check the status of Black mark sensor
2. Check if Dip switch # 6 is correctly set
(Dip switch # 6 is set by On in case of not using
Black mark)
Check the AP version and initialize
Close the lever of print head completely
6. Appendix