Sapling Prayer Clock Installation Manual page 25

Table of Contents

Mandatory Network Configuration – for both IP Hard-Wired and Wi-Fi

DST (Daylight Savings Time) Rule Configuration:

In the "DST" tab for Hard-Wired IP clocks and the "DST Settings" tab for Wi-Fi clocks (shown in the following

images), the user can set the DST (Daylight Savings Time) Rule. If the country (or state) that the clocks (displays)

are being installed in does not follow DST rule, make sure to change the value to: "None" (failing to do so

will cause the clock to to display one hour off than the correct time when DST rule takes place).

If the country (or state) that the clocks (displays) are being installed in follows the DST rule, configure the

GMT/UTC offset for the location where the clock is being installed. If you are unsure of the GMT/UTC offset

rule of the location of where the clock is being installed, you can look it up on the following website:

https://www.timeanddate.com/time/map/

Methods for Defining DST - There are four methods for defining Daylight Savings Time. The method can

be selected from the drop-down menu.

1. Day of the Week in the Month - This mode allows the user to select the day of the week, month, and

time for when the clock will switch to Daylight Savings Time. Example: Second Sunday of March at 2:00.

2. Day of the Month - This mode allows the user to select the specific day of the month and time for

when the clock will switch to Daylight savings time. Example: March 1st at 2:00.

3. By Country - This mode allows the user to select preset Daylight Savings Time information associated

with a specific country or group of countries.

4. None - This mode does not change the clock for Daylight Savings Time.

When finished, press the "Submit" button at the bottom.

Hard-Wired IP Clocks

Wi-Fi Clocks

The Sapling Company, Inc.

670 Louis Drive

Warminster, PA 18974

USA

P. (+1) 215.322.6063

F. (+1) 215.322.8498

www.sapling-inc.com

Table of Contents

Need help?

Do you have a question about the Prayer Clock and is the answer not in the manual?