Installer Code - Bosch AMAX panel 2100 Installation Manual

AMAX panel
–
User Macro Authorizing
For each user, up to three recordable macros can be assigned.
Keyfob ID
Keyfobs are designed for arming and disarming the system remotely, trigger a panic alarm, or
for additional control functionality. For each user, one keyfob ID can be assigned
To operate the buttons, press and hold either button for at least one sec in order to use the
desired feature.
The AMAX panel identifies keyfob users by device RFID. AMAX Keypad programming supports
entering RFID automatically for Radion devices.
4
Keyfob Button 3
For the keyfob button 3 the following settings can be selected:
0 – not used
1 – output control
2 – STAY arm
6.2.2

Installer Code

The installer code is designed to program the AMAX panel. In addition, the installer code is
used for some code commands.
The default installer code is "1234". This code should be changed to an individual code.
Notice!
Identical codes are not allowed. User codes are not permitted to be the same as the installer
code.
Quick keypad operations
The following table shows an overview of the quick keypad operations and the corresponding
user permissions of user codes and installer codes.
Function
AWAY Arm
AWAY Arm All Areas (only on
master keypad)
Direct AWAY Arm (only on
master keypad
STAY Arm
Bosch Sicherheitssysteme GmbH
All manuals and user guides at all-guides.com
For Master User 1 and 2:
For master users all areas are automatically assigned although they are displayed as
unassigned on the keypad. Areas can not be unassigned. Changes in this option only
apply to keyfobs.
For example: If 01 and 02 is selected in this option, all areas are assigned and keyfobs are
assigned to area 01 and 02.
When the keyfob RFID is asked for, press [*] for 3s to toggle between AUTO and
MANUAL mode.
When MANUAL is selected, enter the 9-digit RFID manually.
When AUTO is selected, trigger the RF device and the RFID is entered automatically.
Installation Manual
Command
Default User Code = 2580 / 2581
Default Installer Code = 1234
[code] + [#] / [#] for 3 sec. (quick arm)
[code] + [0] [0] + [#]
[code] + [2-digit area no.] + [#]
[code] + [*] / [*] for 3 sec. (quick arm)
Settings | en 49
D A B S M M I
1 2 N
√ √ √ √ √ √ √
√ √ √ √ √ √ √
√ √ √
√ √ √ √ √ √ √
2015.05 | 06 | F.01U.309.277