Rf Radion Receiver; General; Address Setting; Wiring - Bosch AMAX panel 2100 Installation Manual

24 en | Optional Modules and Peripheral Devices
LED Condition
On
Flash
Off
Table 4.12: DX4020-G System Status Indicator
4.9

RF Radion Receiver

4.9.1

General

The RADION receiver OP is a wireless receiver that connects the RADION wireless system
components to AMAX 3000 / 3000 BE / 4000. Features include the following:
–
–
–
–
Installation
1.
2.
4.9.2

Address Setting

Set the rotary switch to 1. The AMAX panel supports only one receiver.
4.9.3

Wiring

1.
2.
4.9.4

Status Indicator

The following table describes the system status indicator of the RFRC-OPT Radion receiver.
On
Stable flash
Turns off momentarily
2015.05 | 06 | F.01U.309.277
All manuals and user guides at all-guides.com
Cover and wall tamper protection
RFID and configuration data contained in persistent memory
Detection and reporting of radio frequency interference
Support of two types of device enrollment
Disconnect all power supplies of the AMAX panel before installing B450.
Mount the receiver onto a wall in a location accessible for future maintenance using the
provided anchors and screws. For best reception, place the receiver in a central location
among the transmitters. In situations where there is a large distance between the
transmitter and receiver, it might be necessary to install receivers for optimum results.
Connect the RADION receiver to the option bus.
Make sure that the cable distance to the AMAX panel doesn't exceed 300 meters.
LED Condition
Normal operation
Receiver is being programmed with the zone and transmitter IDs
from the AMAX panel.
Receiver has obtained a valid transmission from a RADION
transmitter.
Installation Manual
Denotation
Normal Condition
Trouble Condition
Power Failure
Denotation
Bosch Sicherheitssysteme GmbH
AMAX panel