Bosch AMAX panel 2100 Installation Manual page 80

80 en | Settings
The dynamic battery test is performed every four hours after the system is powered up and
every time the system is armed.
The output is reset in the following cases:
–
–
If the output time is set to 000, the output will continue until the battery is restored and the
fault is reset.
13 - Tamper
This output is operated when a tamper occurs.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the tamper condition is restored
and the tamper is reset.
14 - External Fault
This output is operated when an external fault occurs.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the external fault is restored and
the fault is reset.
15 - All Faults
This output is operated when a fault occurs.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the fault is restored and the fault
is reset.
16 - Fire Alarm
This output is operated when a fire alarm occurs.
17 - Fire Reset
This output is operated when a fire alarm is reset.
18 - AWAY Armed
This output is operated when the system is in AWAY mode.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the system is disarmed.
19 - STAY Armed
This output is operated when system is in STAY mode.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the system is disarmed.
20 - Reset
This output is operated when a reset is performed in the system.
21 - Follow Zone Event Zone Number
This output imitates the zone alarm state. The output is operated when an alarm or a tamper
is generated in the corresponding zone.
2015.05 | 06 | F.01U.309.277
All manuals and user guides at all-guides.com
A dynamic battery test reports that the backup battery voltage is normal and the fault is
reset.
The programmed output time ends.
Installation Manual
AMAX panel
Bosch Sicherheitssysteme GmbH