Installing/mounting
5.2 Installation instructions
5.2.5
Emitter unit
1. Gently unfasten the housing lid of the emitter unit by unscrewing four bolts.
2. Separate the lid from the housing, until the end of wire hinges. Keep horizontal direction
(perpendicularly to front side).
3. Gently tilt the lid at an angle (maximum 110°) to allow easy access to the components inside
the housing.
5.2.6
Receiver unit
Cautiously dismount housing lid by unscrewing each of the four bolts. The receiver unit lid is only
attached by the bolts.
34
Maximum angle of central unit lid opening
Operating Instructions, 05/2023, A5E51429088_AA
SITRANS TDL