Stopwatch - Kustom Signals Golden Eagle II Operator's Manual

7.5.

Stopwatch

1. To enter the Stopwatch mode, press and hold the MODE
switch for more than one second. The road graphic
indicators will turn off and the STPW/TEST LED
indicator will be lit.
2. The LOCK/E.T. (Lock/Elapsed Time) window will
display "0.0" and the PATROL/DIST window will
display the last distance entered.
3. To toggle the activation of the alert tone (beep at start
and stop of timing), press the HOLD switch. (This
procedure cannot be done during a timing cycle.)
4. Measure the distance between two marks. To change
the distance displayed in the PATROL window, depress
either the AUDIO (down) or RANGE (up) switches.
Distances between 100 and 999 yards can be entered.
Holding the switch depressed will cause the numbers to
increase or decrease at a faster rate.
5. When the target vehicle is at the first timing mark,
depress the LOCK/REL switch. The timer is started
and a short alert tone will be heard (if the alert tone
feature has been enabled). When the target vehicle
crosses the second timing mark, again depress the
LOCK/REL switch, which stops the timer and another
short alert tone will be heard.
The alert tones are used to verify the acceptance of the
start and stop commands.
6. The Golden Eagle II will calculate the average speed of
the target vehicle and display the truncated (rounded
down) speed in the TARGET window. The elapsed
time (rounded up to the nearest tenth second) will be
displayed in the LOCK/E.T. window.
Section 7--System Operation
7.15