Table of Contents
Advertisement
Section 12—Troubleshooting
No patrol speed (unit
not in lock) (cont)
Speedometer input will
not synchronize
If speedometer input is used:
Verify unit is synchronized to
p
atrol vehicle (see 6.7).
Verify patrol speed is above 10
M
PH (16 km/h).
Verify antenna is aimed properly
and is not obstructed.
Remove unit from service if above
tests fail.
Verify unit is not in HOLD.
Verify the speedometer input cable
is connected properly.
Verify the remote control is
connected properly.
Patrol speed must be between 30-
70 MPH (48-112 km/h). (Refer to
Sec. 6.7.)
If above tests fail, remove
speedometer input cable from rear
panel and depress TEST switch.
Unit will now function as standard
radar.
12.5
Advertisement
Table of Contents
