Section 6--Testing Procedures
6.5.0. Stationary & Moving Opposite Direction
1. If the unit is displaying "Hld" in the TARGET window,
depress the FRNT/HOLD or REAR/HOLD switch to
select the antenna to be tested. If necessary press the
MODE switch to place the Golden Eagle II in the
stationary mode (both direction antenna/mode
indicators should be on).
Select
Antenna
FRNT
HOLD
REAR
HOLD
2. Depress and hold the RANGE (up) switch until 6 is
displayed in the PATROL window (maximum range).
After releasing the RANGE switch, the "rnG" display
will remain for 2 seconds then the displays will return
to normal operation.
3. If the unit has "DCM" antennas, momentarily press the
TEST switch to enter the TEST mode. The
STPW/TEST indictor will be flashing while in the
TEST state. The radar system will remain in the TEST
state for 30 seconds. Note: pressing the TEST switch
while the unit is in TEST mode will cancel TEST mode
immediately.
4. Lightly strike the lower speed (30 MPH, 35 MPH, or 45
km/h) tuning fork on a hard, non-metallic surface.
Position and hold the tuning fork approximately 1 inch
in front of the antenna.
5. Verify that the TARGET speed displays the same speed
as the tuning fork (30, 35, or 45).
Select
Stationary
MODE
6.4
or