Processing Unit Rear Panel - Kustom Signals Golden Eagle II Operator's Manual

Section 4—Unit Description
4.1.

Processing Unit Rear Panel

R/A F/A
REMOTE PORT 1
SPDOMTR
The rear panel of the Golden Eagle II has connectors for
the remote control, speedometer input, RS232 I/O port and
two antennas. In addition, there is a captive power cord
attached to the rear panel.
Located on the left side of the rear panel is a 3.5 mm
connector for the external wired remote control.
Next to the remote control connector is the Speedometer
Input Cable connector. This cable attaches to the vehicle's
speed sensor to assist in processing proper patrol speed and
for automatic moving/stationary mode switching.
PORT 1 provides the interface to a Kustom Signals
®
Eyewitness in-car video system or Giant Display. All
operations of the Golden Eagle II can be controlled from
external devices via input into this port. This port's output
provides all speeds and status information to external
devices.
The two antenna connectors are marked "R/A" (Rear
Antenna) and "F/A" (Front Antenna). Ensure the antenna
cable(s) are connected to the correct location.
The power cord is permanently attached to the logic unit. It
supplies power to the system from the patrol vehicle's
cigarette lighter receptacle, auxiliary power receptacle or
portable battery pack. The power input is reverse polarity
protected and protected from over-voltage and over-current
conditions.
4.4