Kustom Signals Golden Eagle II Operator's Manual page 14

Section 3—Inspection & Mounting
3.2.1. Indicator Unit
CAUTION: Equipment mounted in 1994 and later
series police vehicles may interfere with the
operation of passenger side airbags. Please refer
to the vehicle manufacturer or your Kustom
Signals District Manager for additional
information on safe mounting areas within the
vehicle.
1. The indicator unit consists of two components: the front
display panel, which contains the unit's displays and
switches, and the processing unit, which contains the
main processing circuit board. These two components
can be mounted in the vehicle as one piece or they can
be separated and mounted in different locations.
The Golden Eagle II display panel can be located
overhead, on the dashboard or on the radio rack. The
logic unit can be located under the dash, in the glove
box or under the front seat.
2. Locate mounting bail. Position the indicator for best
viewing position in the patrol vehicle and mark the
location for the mounting screws.
3. Drill a small pilot hole at the marked locations.
4. Set the bail bracket in place and secure to the dashboard
or other mounting location with mounting screws.
5. If the logic section is separated from the display,
consider mounting it in a convenient yet protected
location, i.e. under the dash, in the glove box or under
the front seat. The interconnect cable for the two
components attaches to the rear of the display unit and
front of the processing unit.
3.3