Rear Panel - Kustom Signals Directional Golden Eagle II Operator's Manual

Section 4—Unit Description

4.1 REAR PANEL

The rear panel of the Directional Golden Eagle II has
connectors for two antennas, remote control, RS232 I/O port
and Speedometer input cable. In addition, there is a captive
power cord attached to the rear panel.
Located on the left side of the rear panel is a 3.5 mm
connector for the external remote control. This connector is
used for the wired remote control.
Next to the remote control connector is the Speedometer
Input Cable connector. This cable attaches to the vehicle's
speed sensor to assist the DSP to process proper patrol
speed.
®
PORT 1 interfaces to a Kustom Signals Eyewitness in-car
video system or Giant Display. This port provides speed
and status information to external devices.
The two antenna connectors are marked "R/A" (Rear
Antenna) and "F/A" (Front Antenna). Ensure the antenna
cable(s) are connected to the correct location.
The power cord is permanently attached to the logic unit. It
supplies power to the system from the patrol vehicle's
cigarette lighter receptacle, auxiliary power receptacle or
portable battery pack. The power input is reverse polarity
protected and protected from over-voltage and over-current
conditions.
__________________________________________________
4.4