Table of Contents
Advertisement
TOOLING SET-UP
1. With the machine bare of tooling, and spindle at approximately 90°, the next set of tooling
can be installed.
2. Select the next size tooling, making sure all of the components match the required tube size
i.e.: bend die, clamp die, pressure die, wiper die, and mandrel.
Aligning Index Table
1. Set the mandrel extract bracket to match the die CLR. Make sure lock bolts are tight on both
the mandrel extraction bracket and the index carriage.
2. Set the IDX carriage to match the die CLR.
Figure 14 Aligning Extraction Bracket
Figure 15 Aligning Index Carriage
32
32
Advertisement
Table of Contents
