Table of Contents
Advertisement
ASSEMBLY AND SET UP
WARNING:
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
Attaching the Legs
1. Use slings to remove the magnet body from the crate. Rest the
body on wooden blocks.
2. Attach the feet to columns using the M8x16 button-head screws.
Install the feet under the columns with the short end forward. Left
foot shown (fig. 3).
3. Tighten the button head screws securely.
4. Carefully lay the brake on its side and then place in an upright
position with a suitable lifting device.
Tool Tray and Back Gauge Supports
1. Using (3) M8x12 socket cap screws attach
the tool tray to the back of the brake.
2. Lay the rubber mat into the tray.
3. Attach each back gauge bar to the brake with
(2) M8x16 socket capscrews.
4. Tighten securely.
5. Slide a back gauge collar onto each bar as
shown in (fig. 4).
For your own safety, DO NOT connect the machine to the
Back gauge collar
Tool tray
Back gauge
support
15
15
A
figure 3
figure 4
Advertisement
Table of Contents
