Introduction; Assembly And Set Up - Baileigh Industrial MB-350 Operator's Manual

INTRODUCTION

• You have made a MB-350 Mandrel Fully Programmable Bending Machine. It has been
carefully built of high quality materials and designed to give many years of efficient service.
The simplicity of design and minimum effort required to operate the machine contributes
towards meeting schedules and producing greater profits.
• The MB-350 Mandrel is an electric powered rotary draw mandrel bender. A user-friendly
touch screen operating station can store up to 140 bend programs with 10 sequential bends
inside of the main program.
• The MB-350 Mandrel was designed to use Pines #2 Style tooling The MB-350 Mandrel you
have purchased is built of solid steel ensuring maximum rigidity. Tongue and groove design
with grade 8 bolts throughout provides very high rigidity and stability.

ASSEMBLY AND SET UP

WARNING:
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
1. Once unloaded, the machine can be positioned in the desired location.
2. Be sure to rest machine on a flat surface, using the adjusting screws to level. After the
machine is leveled, anchors may be used to fasten it to the floor.
3. The mandrel extraction table needs to be level and
square with the base machine, torque (6) 5/8-11
mounting bolts to 100ft/lbs.
4. Attach the mandrel extraction table under the main
spindle plate as shown.
5. Have a certified electrician install and inspect the
electrical connection, and the incoming voltage to
verify that it is correct for the machine before the
machine is turned on.
For your own safety, DO NOT connect the machine to the
14
14