Table of Contents
Advertisement
Manual Bend
1. Select this feature to bend manually without the need to create a program. The actual
degree will be displayed while in this mode. This mode also allows you to enter in one bend
angle and on spring back value (Figure 30)
2. With the arrow keys a bend speed from 1-6 can be selected
OEM menu & Homing
1. To set the home position, you must access the OEM screens, consult Baileigh for the
password, once in the OEM MENU press the HOMING ROUTINE button, and follow the
directions on the screen to set the home position. The Home position is saved forever even if
the power is shut down. You may loose the home position if power is lost to the machine
during a move or if wiring or electronics are disconnected inside the electrical cabinet.
2. Any other parameters in the OEM MENU should only be done after consulting Baileigh Ind.
changing these parameters without consulting will void the warranty.
Creating a Program
1. Choose "RUN, VIEW OR EDIT A PROGRAM" from the MAIN SCREEN (Figure 26)
2. Select a program number from 1 to 140 (Figure 27)
3. When you reach the desired program number, press, VIEW EDIT (Figure 27)
4. On the edit screen enter the desired PROGRAM NAME by touching that field
5. Enter the bend ANGLE (Figure 33)
6. Enter the SPRING BACK (Figure 33)
7. Enter the SPEED from 1-6
8. Enter an Index Table Linear Position if desired
9. Enter a MATERIAL ROTATION if desired.
10. Repeat above steps for Bends #2 to #10.
11. Press the <F1> key to save all data. (Note: if escape key is pressed, data will be lost)
19
19
Advertisement
Table of Contents
