Table of Contents
Advertisement
Running a Program
1. Choose "RUN, VIEW OR EDIT A PROGRAM" from the MAIN SCREEN (Figure 26)
2. To edit a program, choose the program you wish to edit my entering a number or by using
the up down arrow keys (Figure 32). After selecting the program touch the RUN button and
the program parameters will be displayed (Figure 35)
3. Bend data will be displayed (Figure 35).
4. Press and hold the Forward foot pedal down to produce the sample bend.
5. When at the final position, the screen will read, "PRESS REVERSE PEDAL TO HOME
(Figure 36)
6. Press and hold the reverse foot pedal until the spindle reaches "0"degrees.
7. If a second bend was programmed, this will be the next bend and so on all the way to the
last programmed bend up to bend 10
8. If no data was entered after bend 1, bend 1 will be repeated until escape is pressed.
Dry Running
1. Once you are familiar with the machine and programming unit, it is important to dry run a few
programs.
2. Follow the previous steps to produce a generic bend and dry run without material.
3. Repeat this process as many times as needed to fully understand the functions and controls.
4. It is always a good idea to remove the mandrel for dry running the machine.
IMPORTANT: THE DO NOT ATTEMT TO OPERATE IF YOU ARE NOT
CONFIDENT, OR DON'T UNDERSTAND THE CONTROLS.
20
20
Advertisement
Table of Contents
