Table of Contents
Advertisement
TECHNICAL SPECIFICATIONS
Minimum CLR (Center Line Radius)
Maximum CLR (Center Line Radius)
Square Tube SS & MS
Capacities Round OD (Mild Steel)
Capacities Round OD Stainless Steel
Minimum Practical Material Diameter
Bending Power
Bend Direction
Mandrel Rod Size
Material Feed
Index Chuck Thru Hole
Index Table Length
Maximum Bend Speed
Maximum Bend Angle
Maximum Hydraulic Pressure
Hydraulic Motor
Power
Shipping Weight
TECHNICAL SUPPORT
Our technical support department can be reached at 920.684.4990, and asking for the support
desk for purchased machines. Tech Support handles questions on machine setup, schematics,
warranty issues, and individual parts needs: (other than die sets and blades).
For specific application needs or future machine purchases contact the Sales Department at:
sales@baileighindustrial.com, Phone: 920.684.4990, or Fax: 920.684.3944.
Note: The photos illustrations used in this manual are representative only and may
not depict the actual color, labeling or accessories and may be intended to illustrate technique
only.
Note: The specifications and dimensions presented here are subject to change
without prior notice due to improvements of our products.
1.5 x diameter (38mm x diameter)
9" (736mm)
2.0" x 2.0" x .120" wall (50 x 50 x 3mm)
3.0" x .120" wall (76 x 3mm)
3.0" x .065" wall (76 x 1.6mm)
1" (25mm)
4hp (3kw)
Clockwise
1" diameter x 1"-8 Thread
1" (25.4mm)
2.4" (61mm)
10ft. (3048mm)
180 degrees in 16 seconds
200 degrees
3000psi (20.68mPa)
5hp (3.75kw)
220V / 3-phase / 60hz
4000lbs. (1819kgs)
9
9
Advertisement
Table of Contents
