Table of Contents
Advertisement
Installing Tooling
First slide the bend die onto the center pin, the drive key will engage the bend die, be sure it is
fully seated down to the spindle. Install the spindle locknut and torque to 125 ft. lbs.
1. The clamp die can be latched onto its holder making sure it is fully seated, with half round
key in slot in back of the clamp die.
Figure 16 Clamp Die Holder is fully Seated
Figure 17 Clamp Die is not seated properly
2. Install guide sleeve onto mandrel shaft to fit material being bent.
33
33
Advertisement
Table of Contents
