Table of Contents
Advertisement
INITIAL BENDING
CAUTION:
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials make sure they are properly supported.
Keep hands and fingers clear of the machine when activating the hydraulics.
Stand off to the side of the machine to avoid getting hit with the bending apron as it
swings to bend the material.
It is recommended to use Tower Draw Lubrication (part # TC-86) for mild steel and stainless
steel applications. For direct purchased contact Tower Oil and Technology (1-800-654-9588).
1. Double-check that all of the tooling set-up and verify it is correct.
2. Apply a liberal amount of lube to the mandrel.
The first picture shows how much lubrication to apply to the mandrel; the second picture shows
not enough lubrication and could result in the mandrel being locked in the tube during the bend.
IMPORTANT:
MANDREL INSIDE OF THE TUBE.
Always wear proper eye protection with side shields, safety
Figure 23 Lubrication of Mandrel
VERY IMPORTANT! NOT ENOUGH LUBE COULD LOCK THE
38
38
Advertisement
Table of Contents
