Assembly And Set Up; Anchoring The Machine - Baileigh Industrial EW-21 Operator's Manual

ASSEMBLY AND SET UP

WARNING:
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
1. Using the M10 x 1.5 x 25 Hex FLG bolts and M10 x
1.5 FLG Nuts included, install the four leg brackets
(A) onto the frame.
2. Once the legs have been installed, the machine
may be placed and secured in location.
3. Install the Kick Wheel (B) onto the ram shaft with
the key and socket head cap screw.
4. Using the M10 x 1.5 x 25 Hex FLG bolts and M10 x
1.5 FLG Nuts included, install the anvil storge
bracket (C) onto the frame. The bracket may be
mounted on either side of the frame.

Anchoring the Machine

This machine is intended to be mounted on a bench
top; therefore, when mounting the Baileigh English
Wheel on a workbench be aware of the following:
• Overall weight of the machine and the weight of material being processed.
• The dynamic forces that will occur during operation from pushing and pulling material
through the wheels.
• Make sure the workbench is properly reinforced to support the total weight.
• The strongest mounting option is where the holes are drilled all the way through the
workbench and the machine is secured with bolts, washers, and nuts.
Mounting the Machine
1. Ensure that the workbench is secure and meets the minimum requirements listed.
2. Place the machine in the desired location and check for full operating clearance for the
machine, materials, and the machine adjustments.
3. Once the position has been determined, use the mounting legs as a template and mark the
hole locations.
4. Move the machine aside enough to remain secure, and to allow access to the marked holes
to drill mounting holes as needed.
For your own safety, DO NOT connect the machine to the
B
12
12
C
A