Table of Contents
Advertisement
3. Apply a small amount of lube to the tip of the wiper die. Too much lube on the wiper die will
cause wrinkles.
4. Slip the material over the mandrel.
5. On the hydraulic screen (F4) extend the clamp die. Note the clamp die's pressure and make
sure it is right for the application.
IMPORTANT:
DAMAGE TO THE CYLINDER ROD.
6. Extend the mandrel the green light will illuminate.
7. Extend the pressure die making sure it is engaging the tubing.
8. Press (F5) and select manual mode.
9. Grease the mandrel using the grease zerk (10 pumps min.).
Figure 24 Applying Lubrication to the Wiper Die
TOO MUCH PRESSURE ON SMALLER DIE SIZES MAY CAUSE
Figure 25 Greasing Mandrel via Zerk Fitting
39
39
Advertisement
Table of Contents
