Assembly And Set Up - Baileigh Industrial HSP-30M Operator's Manual

ASSEMBLY AND SET UP

WARNING:
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
Note: The hydraulic unit weights about 90lbs (41kg). For placing the unit in the
correct position, use and assistant or safe lifting equipment to lift the unit.
During shipping, the hydraulic unit is mounted in
the inside of the frame.
To place the unit in working position:
1. Remove and retain the two cap screws (A)
holding the hydraulic tank assembly to the
shipping mount.
2. Place the hydraulic assembly on the
mounting bar on the right side of the press
and install the two cap screws removed from
the shipping mount. Tighten securely.
3. Install the upper support bolt (B) into the
weld nut near the top of the tank.
4. Tighten the bolt until the tank is level. The
tank may lean outward (toward the drain
plug) up to 2°.
5. Tighten the jam nut to the frame plate.
6. Route the hydraulic hoses (C) to the
hydraulic fitting and matching the letter
labels (A to A and B to B), one at a time,
remove the plastic caps and install the hoses
to the fittings. Tighten securely, however do
not over tighten and distort the swivel fitting
collar.
7. Fill the tank with hydraulic oil. The press is
shipped without oil. Before starting up, the
tank needs to be filled with hydraulic oil #68
SHELL BRAND or an equivalent with similar
specifications.
For your own safety, DO NOT connect the machine to the
16
16
A
C
B