Gas Section - BORETTI CFBG902AN3 Instruction On Mounting And Use Manual

9 Gas section

The walls adjacent to the cooker must be of material resistant to heat.
Gas connection
The connection must be executed by a qualified tecnician according to the
relevant standards. The appliance is predisposed and calibrated to operate
with the gas indicated on the specifications plate.
Before installation, make sure that the local distribution conditions
(type of gas and its pressure) and the adjustment of this appliance are
compatible. The appliance adjustment conditions are given on the plate
or the label.
Ensure that the room in which the cooker is to be installed is adequately
ventilated, in compliance with applicable regulations. Connection to the
gas supply pipe or gas cylinder must be made in accordance with the
requirements of the applicable regulations.
The gas supply is connected at the rear of the cooker (fig. 9.1) to the R or L
terminal of the gas inlet pipe; the connection pipe must not cross the rear of
the appliance. The terminal not used must be closed off with the plug T and
gasket.
R
53
L
T
Fig. 9.1