Cleaning And Maintenance; Enamelled Parts - BORETTI CFBG902AN3 Instruction On Mounting And Use Manual

7 Cleaning and maintenance

General advice
* Before you begin cleaning, you must ensure that the appliance is
disconnected from the electrical power supply.
* When the appliance is not being used, it is advisable to keep the gas tap closed.
* The periodical lubrication of the gas taps must be done only by specialized
personnel.
* If a tap becomes stiff, do not force; contact your local After Sales Service Centre.
* It is advisable to clean when the appliance is cold and especially when cleaning the

enamelled parts.

* Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the
surfaces.
* Avoid using cleaning products with a chlorine or acidic base.
* Important: The use of suitable protective clothing/gloves is recommended
when handling or cleaning of this appliance.
Warning
When correctly installed, your product meets all safety requirements
laid down for this type of product category. However special care
should be taken around the rear or the underneath of the appliance
as these areas are not designed or intended to be touched and may
contain sharp or rough edges, that may cause injury.
Enamelled parts
All the enamelled parts must be cleaned with a sponge and soapy water or
other non-abrasive products. Dry preferably with a microfibre or soft cloth.
Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage
the enamel if left too long.
37