Anti-Tilt Bracket - BORETTI CFBG902AN3 Instruction On Mounting And Use Manual

Anti-tilt bracket

Warning
This appliance must be restrained to prevent accidental tipping by fitting
a bracket to the rear of the appliance and securely fixing it to the wall.
To fit the anti-tilt bracket:
1. After you have located where the cooker is to be positioned, mark on the
wall the place where the 2 screws of the anti-tilt bracket have to be fitted.
Please follow the indications given in fig. 8.8.
2. Drill two 8 mm diameter holes in the wall and insert the plastic plugs
supplied. Important! Before drilling the holes, check that you will not damage
any pipes or electrical wires.
3. Loosely attach the anti-tilt bracket with the 2 screws supplied.
4. Move the cooker to the wall and adjust the height of the anti-tilt bracket so
that it can engage in the slot on the cooker's back, as shown in fig. 8.8.
5. Tighten the screws attaching the anti-tilt bracket.
6. Push the cooker against the wall so that the anti-tilt bracket is fully inserted
in the slot on the cooker's back.
Attention!
When sliding the cooker into place pay special attention not to trap the
power supply cable in the stability bracket.
Pay special attention to the gas connection hose.
Fig. 8.8
51