Rational iCombi Pro Original Installation Manual page 56

6 | Electrical connection
2. Set the voltage at the switch according to the power supply. In the basic
position, the switch is in position 2:
Position
1
2
3
1. Close the electrical compartment.
2. Connect the unit to the power supply.
3. Switch the unit on.
4. Select the service level using the control panel. Navigate to the Basic set-
tings - Other - Installation voltage. Set the voltage.
5. Switch the unit off and on again. The changes are now applied.
6. Perform a performance review. Check that the measured performance val-
ues ​ ​ m atch the information on the nameplate.
56 / 108
1
Voltage (V)
240
208 / 440
480
80.06.070_iCombiPro-iCombiClassic_IM_en-GB
2 3