Transport With Lifting Aid - Rational iCombi Pro Original Installation Manual

4 | Transport
4. Lift the standalone unit with the pallet jack.
5. Transport the unit to its intended installation surface.
>>
The unit is standing on its intended installation surface and is ready for in-
stallation.
4.4

Transport with lifting aid

Only transport the unit sizes 6-1/1 to 10-2/1 with the lifting aid.
Only genuine service parts may be used.
n
Check the lifting aid before using. The lifting aid must not be used in the
n
event of wear or damage.
Use the lifting aid as described. Modifying, extending or alternative use of
n
the lifting aid is not permitted.
The lifting aid may only be lifted by hand. Use with other lifting equipment
is not permitted.
Risk of crushing when positioning the unit
Fingers, hands and feet could be crushed beneath the unit.
Wear appropriate protective clothing when positioning the unit.
n
Only lift the unit at the intended lifting points.
n
Risk of crushing and injury if unit is incorrectly lifted with the lifting aid
Hands, fingers or feet could be crushed.
Ensure that the lifting aid, installation surface and protective clothing are
n
clean and grease-free.
Only lift the unit with the bars of the lifting aid by hand. Do not use any
n
mechanical aids to lift the unit.
Sharp edges on the housing
Risk of cuts on the housing when working in the electrical compartment.
Wear protective gloves.
n
Only transport the unit at the approved transport points.
n
24 / 108
CAUTION
CAUTION
CAUTION
80.06.070_iCombiPro-iCombiClassic_IM_en-GB